Post here if you have general questions concerning GunCAD, printing, or otherwise fabricating DIY firearms. Newbies are welcome, but users are encouraged to read Ctrl+PEW's Getting Started Guide if they haven't already.
Shitty stock image may be changed at moderator discretion.
I was wondering what can be done to fix this issue with my fgc 9? Using the hickory hills bolt and barrel.
That’s wild, you okay? Never seen it before, what trigger group are you using? Check your sear and trigger reset function.
Just using a standard mil spec trigger, used to be using the csgcg but never worked with the cnc bolt.
To my knowledge this is usually caused by hammer-follow, or a stuck firing pin.
As the bolt closes home, if the firing pin is stuck it can detonate the primer prematurely.
Or if the trigger reset sear is not catching the hammer and holding it until you release the trigger, the hammer can follow the bolt home rather than being held down until you release the trigger, thus hitting the firing pin before the bolt is fully in battery