I was wondering what can be done to fix this issue with my fgc 9? Using the hickory hills bolt and barrel.
this post was submitted on 30 Nov 2025
9 points (100.0% liked)
Help & Support
185 readers
26 users here now
Post here if you have general questions concerning GunCAD, printing, or otherwise fabricating DIY firearms. Newbies are welcome, but users are encouraged to read Ctrl+PEW's Getting Started Guide if they haven't already.
Shitty stock image may be changed at moderator discretion.
founded 2 months ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
To my knowledge this is usually caused by hammer-follow, or a stuck firing pin.
As the bolt closes home, if the firing pin is stuck it can detonate the primer prematurely.
Or if the trigger reset sear is not catching the hammer and holding it until you release the trigger, the hammer can follow the bolt home rather than being held down until you release the trigger, thus hitting the firing pin before the bolt is fully in battery