LadPack91

Assuming rails are SCS?

If so I'll wait till the drop and get it all at once

Any rough idea when the drop will be?

Have my parts coming in for my pwc-9 build. Will there be any changes required for the collapsing brace to any of the main files?

AFAIK there are no FRT for the original Mac form factor, is this true here too?

Excellent! Great work and they look great

Have you had any failures on the pwc9 yet? I know the question of filament/skill/printer etc is always a topic. Any failure mode to look out for?

I might be looking for a sister for my alloy soonish.

For the either (but more focused on the 9mm) what's the estimated longevity on these? I know the DB alloy had the side plates for some longevity improvements.

Also for packability how does this compare to a DB alloy size wise?

I think it hits that perfect sweet spot of Glock gen 3 compatible and the FCU

Do you have a source for tx22 lpk?

Yeah wouldn't be too hard. I'm gonna do one for the minivader.

Question on the Button

Does the M4x20 thread into the button itself? Then it reciprocates with the button being pressed?

Following up here for future people maybe.

Issue was resolved with an extractor, spring and bushing replacement

For those with an FM-15. The FM-15 gen 2 as of 2025 no longer uses a proprietary extractor pin.

Use standard, FA rated extractor, spring and pin (and rubber bushings)

No need to buy from FM or change the firing pin as on the early gen 2 models

This was confirmed by FM support

Also found this one, since it is bolt on it may be easy to incorporate.

Going to try my hand at an update for the minvader brace with it. https://a3industries.com/polymer-steady-brace-pistol-stabilizing-brace/