Bb19 in Polymaker Pla pro pink No issues so far only 32 rounds in though 1.6mm layer height 215 temp 60 bed Rails up(prefer rails down) Front sight came off while shooting but that’s my fault. Not the best looking but it functions🫡
this post was submitted on 07 Dec 2025
14 points (93.8% liked)
General Discussion
427 readers
79 users here now
Discuss anything GunCAD related. If you need help, see /c/help. If you think you're discussing a thing a lot of the time, consider making your own separate community.
Abide by the global rules or be smitten.
Shitty stock image may be changed at moderator discretion.
founded 2 months ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
That’s clean for 1.6mm layers 🤪
I should’ve mentioned I added fuzzy skin.