Help & Support

183 readers

19 users here now

Post here if you have general questions concerning GunCAD, printing, or otherwise fabricating DIY firearms. Newbies are welcome, but users are encouraged to read Ctrl+PEW's Getting Started Guide if they haven't already.

Shitty stock image may be changed at moderator discretion.

founded 2 months ago

MODERATORS

TheShittinator

ItsBildo

Alyosha

annealing PA612CF (self.help)

submitted 23 hours ago by Therustynut to c/help

4 comments fedilink hide all child comments

I have a hoffman sl9 running in the bambu as I type. Whats some preferred tips and tricks for annealing. Ive heard the obvious temp and time. Do I leave the supports on while its cooking? thanks.

oh yeah, FUCK Reddit.

you are viewing a single comment's thread
view the rest of the comments

[–] Therustynut 1 points 21 hours ago* (last edited 19 hours ago)

flower salt not sure of what that is,? I was going too anneal in the air firer, same one for drying PA.

Edit, is there a need too add moisture into the print afterwards? Im still a bit new to PACF

ok, did some reading. so can i get away with a dish of regular table salt. then 100c for a whopping 16 hrs? damn.