FOSSCAD

406 readers

1 users here now

A community dedicated to the discussion of 3D printed guns and related topics.

Lemmy

founded 3 years ago

MODERATORS

sado@lemmy.ml

Frt or SS for plastikov (self.fosscad)

submitted 1 week ago by Frankbeans666 to c/fosscad@lemmy.ml

9 comments fedilink hide all child comments

Does anyone have any info on how to set up frt or SS in the plastikov v4? Thanks

you are viewing a single comment's thread
view the rest of the comments

[–] Frankbeans666 1 points 1 week ago (3 children)

Damn I was thinking that there was enough room for the sear but wasn't sure about them safety being an issue or not. Do you think it would be possible to modify the safety on the plastikov? It doesn't seem like it would be too hard to do.

[–] stickygumm_01 1 points 1 week ago* (last edited 5 days ago) (2 children)

There's a hole close to where the sear goes but it's not in the exact location.

Wouldn't be too hard to mod the selector for three position binary, but getting a FRT work will take a lot of time on both the frame and the trigger housing.

[–] Frankbeans666 1 points 5 days ago (1 children)

Was that a typo?

[–] stickygumm_01 1 points 5 days ago

Yes, corrected it