Happened to me as well. For saying google my username lol.
Well, that sucks. Wish I had known these were up in the first place. I’m trying to measure the LCI location to make a plug, but I don’t have a slide here to measure on.
300 is a 7.62 round in a necked down 5.56 case…. So yeah, gonna feel similar. As was previously stated, it was designed to shoot out of the same rifle as 5.56 with just a barrel change.
Much appreciated!
Question, I see there is a .4 and .63. How would I know which one I need to use?
Know your range first of all if that’s where you have to shoot. Secondly, don’t put anything you made inside a range rental. That’s not yours to modify. Thirdly, don’t be dumb (or maybe this should be first?).
I’d potentially have some interest if it means I don’t have to buy a bunch of extra scs parts lol.
To be 100% honest, I’m not sure. I don’t have a 19 mag to test it on
Created a +2 mag extension for my plasticatto build. This is a 31mm ish extension with a large baseplate to limit it to +2 rounds. I limited it here because I know the factory Glock mag springs will work with this.
This should fit all factory Glock 17/34 mags.
These are available on my Makerworld profile along with a few other accessories that might suit your needs.
All finished up, minus the optic which I will be ordering tomorrow!
I’ve heard good things about the pill popper v2