So after one thrown out back and an hour on the floor due to getting old, I can confirm that the remnants trip bar does work with the db9 alloy super safety lower by you. I need to bend the back trip area a few more degrees as its on the very edge of the super safety but other than that, my function tests are going good. Thanks again for responding
abuba8262
joined 1 month ago
What I'll probably do is if this trip bar for some reason doesn't work, then I'll just order new ones with the correct version this time and then get some levers cut from send cut send as well from some material.
Sounds good, ill try it at some point soon as I haven't modified the upper yet and cut out that piece in the back. Also waiting on filament for the super safety lever for the mac
Also for remnants trip bar im assuming i bend the front as well around the curve of the bolt and not like yours is since its missing the extra tab at the front?
So long story short you're saying the metal trip bar (which I ordered on send cut send) from the remnants (Mike???) mac daddy super safety system DOES work with your (PhoenixDesigns/AlexPhoenix) SS DB Alloy, they just bend in different ways and are different shapes but overall get the same function done?
Also you say the rear bend angle is different on remnants, can I use that bend angle in the SS DB Alloy or does it have to be different?
I tried this when it first dropped, didn't work and I just got around to trying it again as I need to order some things from SCS and I like this design but I can never get the Kabuto TURD to work. I don't know what I'm doing wrong but this is as far back as the BCG will go. I tried pulling it back further and when I did, it locked up and had to push the rear takedown pin out, let a small gap pop up and the BCG flew forward.
I just can't get anywhere with this. I'm going to try the Kev remix as it takes milspec 3 pos but I wanted to see if this worked to begin with, which it didn't.
I have both a P1S and an older Q1 and love my Q1. I haven't printed with any fiber filaments yet because I'm lazy and don't feel like it but I will be printing with Bambu PAHT-CF sometime this week for some super safety mac levers and will be using my Q1 (Q2 is just the Q1 with better appearance, hotend temps, chamber temps, and probably build) due to the heated chamber specifically. I have printed ASA a bunch and its always great. You never know how much you want/need a heater chamber until you need to print it with it. Also on the Q1 (not sure about the Q2) has hardened gears and a bimetal hotend (nickle plated copper with a hardened steel tip) from the factory whereas the P1S you have to buy an extra nozzle and gears (If you buy complete hotend its like $35 and the gears are $20). Just something to add to the price.