overview for SgtButters

Need fearless testers for my project. in c/general

[–] SgtButters 1 points 14 hours ago

I believe the minimum relevant group has been assembled. If you'd like to join, you're welcome.

Need fearless testers for my project. in c/general

[–] SgtButters 2 points 4 days ago* (last edited 4 days ago) (1 children)

IMHO pa6cf is too much for prototype which probably have some undiscovered issue. Personally I will stay on PLA, until release version. But different bilds mean more interesting information.

Quite box bullet trap in c/general

[–] SgtButters 1 points 5 days ago

I used setup of 50 litre can filled with 25kg of rubber mulch. 5mm steel plate behind can for safety. All stuff in 60x60x100 box filled with rockwool, at least 15-20 cm each side. Were quite.

Need fearless testers for my project. in c/general

[–] SgtButters 2 points 5 days ago

30x30x1.5 square tube as slide cover and 20x20 square as breechblock.

Need fearless testers for my project. in c/general

[–] SgtButters 13 points 5 days ago* (last edited 5 days ago)

Few more pictures.

25

Need fearless testers for my project. (forum.guncadindex.com)

submitted 5 days ago* (last edited 5 days ago) by SgtButters to c/general

9 comments fedilink

This is Orcbolg. Fully DIY .380 ACP pistol. You may seen it on reddit 3D2A few months ago. Now time to test it. As I live not in land of the second amendment, for me it not so easy. But I did possible for me at this moment and can claim Orcbolg can handle at least 20 shots. About pistol: Not fully printed, but no gun parts, only simple metalworks like drilling and cutting. Slide are composite of printed liner and metal square tube, JB-weld together. Breech face metal too. FGC-9 like barrel. If you feel yousel able to help this project - email me Sgt.Butters@proton.me If you have any question - feel free to ask here. At this moment I am trying to make minimal instructions. As it will be done, i'll start sending instructions and STEP files for everyone who care.