Ju5t3nc4s3

joined 2 months ago
sorted by: new top controversial old
Welcome To The Build Show in c/builds
Pride NaG for the wife in c/builds
[–] Ju5t3nc4s3 4 points 2 months ago* (last edited 2 months ago)

If its splitting at layer lines at front of cage, make sure u don't have hammer springs to strong. Also latest design has a pin that holds cage in the front this helps issue..the lower in pic is older,redownload from official. But the main issue is bad layer adhesion ,turn up temp and print slow very slow. And always use good quality pla+

What types of weapons would you like to see more of? in c/general
[–] Ju5t3nc4s3 2 points 2 months ago (1 children)

I'm working on it

DEFCAD selling my design in c/general
[–] Ju5t3nc4s3 1 points 2 months ago

Good luck. I have written them some nasty emails . You will get nowhere . Are they at least giving you credit by user name? every design they have was taken from some where else for free.