1/8" is 3.175mm. So, yeah, probably.
this post was submitted on 14 Oct 2025
3 points (100.0% liked)
Help & Support
183 readers
17 users here now
Post here if you have general questions concerning GunCAD, printing, or otherwise fabricating DIY firearms. Newbies are welcome, but users are encouraged to read Ctrl+PEW's Getting Started Guide if they haven't already.
Shitty stock image may be changed at moderator discretion.
founded 2 months ago
MODERATORS
Yeah just clean up the hole a bit and function test the firing pin to make sure it doesn't stick
I used a 1/8 too
It's what I used.