Help & Support

185 readers

15 users here now

Post here if you have general questions concerning GunCAD, printing, or otherwise fabricating DIY firearms. Newbies are welcome, but users are encouraged to read Ctrl+PEW's Getting Started Guide if they haven't already.

Shitty stock image may be changed at moderator discretion.

founded 2 months ago

MODERATORS

TheShittinator

ItsBildo

Alyosha

HELP: Threaded hole printing too large/loose (self.help)

submitted 1 month ago* (last edited 1 month ago) by RenegadeSC to c/help

8 comments fedilink hide all child comments

Tested a print of a muzzle device after calibrating some PLA Pro. The print came out looking great. However, the 1/2x28 threads in the ID are very loose, so much that with minimal force, you can pull straight past them.

So, I've seen a few different ways to fix this, but I wanted to see what the community agrees to as the "best" practice to adhere to.

Do I adjust for shrinkage, add in additional tolerance in the modeled threads, or do something else entirely?

Bambu P1S

0.4mm Nozzle

0.16mm Layer Height

Overture PLA Pro

you are viewing a single comment's thread
view the rest of the comments

[–] notsuspekt 2 points 1 month ago* (last edited 1 month ago) (1 children)

Yes.

[–] Skydiver6532 2 points 1 month ago (1 children)

Dope thanks. I've yet to do any of the calibration stuff, but i probably should.

[–] notsuspekt 1 points 1 month ago* (last edited 1 month ago)

With something as stress-prone and tolerance sensitive as 2A components I think it's definitely worth doing. Especially if you modify your printer or use a variety of filaments. Shit, my K1C came basically unusable from the factory. Every upgrade you do requires verification.

I'd rather fail a test print than a 24 hour print job.