General Discussion

425 readers

50 users here now

Discuss anything GunCAD related. If you need help, see /c/help. If you think you're discussing a thing a lot of the time, consider making your own separate community.

Abide by the global rules or be smitten.

Shitty stock image may be changed at moderator discretion.

founded 2 months ago

MODERATORS

TheShittinator

ItsBildo

Alyosha

Help me choose a printer | X1C vs P1S | What's your preferred filament? (self.general)

submitted 2 months ago* (last edited 2 months ago) by RenegadeSC to c/general

20 comments fedilink hide all child comments

Looking to finally make the jump from my old Ender 3 to a better printer, I've upgraded the Ender quite a lot but have run into multiple problems over the years with custom firmwares. During my last move, I snapped the SD card slot off the main board and have had issues getting the new one back up and running. With all of that said I'm ready to just buy once, cry once, and get back to printing.

The options I'm looking at are either the X1C or the P1S. I wanted to get opinions here, as from what I've found so far, the P1S seems to have the same print speed/quality, just minus the AI, and upgraded steel components. How capable is the P1S stock, and what upgrades, if any, would be recommended?

From what I've found, the AMS 2 seems to be the ideal choice over the OG AMS due to the drying function and more user-friendly design. It's $120 more for the AMS 2 combo than the AMS combo, so for those of you who have these setups, is the AMS 2 worth it?

Other than the printer selection, what are your go-to filaments and brands? I've seen PPA-CF, PA6-CF, and PAHT-CF mentioned, but don't really understand the pros and cons of each.

I was a long-time lurker on the Fosscad sub, but I am hoping to contribute moving forward.

you are viewing a single comment's thread
view the rest of the comments

[–] sparrow0914 2 points 2 months ago

X1C owner with original AMS and a separate filament dryer. Realistically, from what I’ve heard from other P1S is probably better bang for the buck. Depending on material, hardened nozzle and extruded gears would be first upgrade. AMS2 does dry, but you cannot dry and print at the same time, or at least I haven’t been able to figure it out.