General Discussion

Hey friends,

I'm writing to see if there is any interest in a DIY parts kit for the SCS Super Safety.

Kits would be for 3-pos.

The kit would include:

- 2x Grade 5 Titanium Wear plates (.04" + 0.06") - tops machined flat
- 2x 1.5mm 304 Stainless Steel Rods - pre-cut to length
- 1x Rounded Brass Detent Pin

Price-wise I'm thinking $10. What do y'all think?

It's a fun project, I've had mine working very well. This cuts down a lot of the SCS and Amazon shopping logistics.

You'd just need a small mallet and some epoxy, maybe a 1.5mm drill bit if your printer isn't super dialed to clear out the holes.

I'll go by the shop and take a photo of what I'm thinking.

I also have pre-cut mil-spec triggers for sale for $20. But if you're in the DIY camp - I think I'd leave it to you for making your own cutting jig and doing your own trigger.

I could ostensibly include an uncut trigger for another $10. But I'm not sure if that's a value add.

LMK if there is interest. Or if the price point is off, etc. Only worth doing if y'all would appreciate it. What do you guys think?

EDIT: Made an initial batch here:

https://greysummitgear.com/products/gsg-09-diy-scs-ss/

$15 - with a stock mil-spec trigger.