(slightly older beta versions in the picture)
Hey all!
Because the "PWC: DLC" (DownLoadable Content, for you boomers and non-gamers) will be releasing soon, I figured I'd make a post and open up a general Q&A about the PWC.
Questions are not limited to the DLC, 9mm, or 5.7 - all questions about the PWC are welcome!
seems like the safety is blocking the trigger from fully coming down thuus pushing the sear/trigger block back to disengage/disconnect the hammer. im guessing the tumbler is supposed to roll back to allow the trigger to come down far enough ? what am i missing here ? will the mpa9mm safety selector work ?
outside of that, the build is complete.. i the meantime i can range test without the safety installed.
re: safety tumbler.
firured out the safety issue. the sear and trigger bar were not correctly installed.
now need to print another charging handle. i would say plastic charging handles are not it. will have to order a metal ch.
You can absolutely print a charging handle, but it has to be nylon.