General Discussion

424 readers

97 users here now

Discuss anything GunCAD related. If you need help, see /c/help. If you think you're discussing a thing a lot of the time, consider making your own separate community.

Abide by the global rules or be smitten.

Shitty stock image may be changed at moderator discretion.

founded 2 months ago

MODERATORS

TheShittinator

ItsBildo

Alyosha

PWC - 9mm and 5.7 - Q&A (forum.guncadindex.com)

submitted 2 weeks ago by unseenkiller to c/general

26 comments fedilink hide all child comments

(slightly older beta versions in the picture)

Hey all!

Because the "PWC: DLC" (DownLoadable Content, for you boomers and non-gamers) will be releasing soon, I figured I'd make a post and open up a general Q&A about the PWC.

Questions are not limited to the DLC, 9mm, or 5.7 - all questions about the PWC are welcome!

you are viewing a single comment's thread
view the rest of the comments

[–] pv2025 1 points 2 weeks ago* (last edited 2 weeks ago) (1 children)

is anyone having to file down the l-brackets ? i cant get them to match up or sit flush in the frame slot. i believe i cleared out the support material from those areas. any other suggestions ? file down brackets ? heat brackets prior to inserting into frame ?

edit.. figured it out..

[–] unseenkiller 3 points 2 weeks ago (1 children)

well? what happened?

[–] pv2025 1 points 2 weeks ago

just had to clear out material in the bracket slots.. i used a thin enough file to clear out the bracket slots and after that was able to sit the brackets in flush.. now i can run the m4 bolts through each bottom bolt hole pairs.

now i am cutting the smooth rods to size..

i took your advice and purchased some extra long smooth rods and just cut them to size as needed.