General Discussion

425 readers

53 users here now

Discuss anything GunCAD related. If you need help, see /c/help. If you think you're discussing a thing a lot of the time, consider making your own separate community.

Abide by the global rules or be smitten.

Shitty stock image may be changed at moderator discretion.

founded 2 months ago

MODERATORS

TheShittinator

ItsBildo

Alyosha

Pa6-cf vs pla+ dimensional accuracy (self.general)

submitted 1 month ago by YeyoGrapes to c/general

7 comments fedilink hide all child comments

Every thing i print in pla+ has been pretty dimensionally accurate on my K1c. However when i print the same thing in pa6-cf. (all fillament sunlu) the dimensions end up slightly smaller and the tolerances are arguably too tight. Magazines dont slide in and out easily, mag catch barely fits and wont slide. Pin holes are too small. Etc.

How would i address this. As it seems filament dependent not printer issue

you are viewing a single comment's thread
view the rest of the comments

[–] Kopsis 1 points 4 weeks ago

Which slicer are you using? Have you calibrated your flow rate? You might be getting some over-extrusion, which combined with 100% infill can lead to dimensional inaccuracy.